WHITTLE V8 AERO ENGINE

Rocker brackets. Sometimes it is a good idea to make some extra parts.
Rocker brackets on top of the cylinder head and timing gears.
Finished timing gears. Note the small slot in each gear.
Cylinder head with bronze valve guides and valves in Place.
It is small and then there are sixteen of them.
It's hard to get good Sharp photos.
Next will be the springs and valve retainers.
Rockers. Al 16 is made by now.
The rockers after blackening process. The length is approximately 15 mm. The internal diameter of the bronze bearing is 2.4 mm.

Skriv en kommentar: (Klikk her)

123hjemmeside.no
Antall tegn tilbake: 160
OK Sender...
Se alle kommentarer

| Svar

Nyeste kommentarer

02.04 | 22:12

Maravilloso trabajo, y preciosa fresadora, yo también restauro maquinas, el problema es que te enamoras de ellas, y cada vez tienes mas maquinas y menos espacio

...
30.03 | 18:05

Haw many maney ?

...
10.01 | 05:04

In my first post--I neglected to say that my machine was a Hoffman--similar to an Agathon 175-175A

this has to be the most beautiful shop in the world--are you a hobbyist---or professional

Thanks for any help you can give me

...
10.01 | 04:52

I need the following:
1. Owners manual in English
2. The handles used to lock the cross bar
3. Any and all accessories
4. Grinding wheels for HSS Lathe bits

Office of Thomas Barr IV
3855 Noyac Road
Sag Harbor, NY 11963
USA
Tel: 631-725-7447
Fax: 631-72

...
Du liker denne siden