SCHAUBLIN 11 A

300514. Schaublin 11 A. After a long trip from Sweden this little machine is finally in my workshop. The machine will need a complete reconditioning and I will post photos as the work goes on.
2 K spray paint after total dismantling and a very thorough cleaning.
My scraping skills have improved very much after the scraping course with Richard King. The final touch is made with bump scraping. My aim is to get the geometry within 0.01 mm in every direction.
Beskrivelse
Beskrivelse
September 2014; Schaublin 11 A, scraping of the ways.
Beskrivelse
Beskrivelse
Beskrivelse
Beskrivelse
The knee is scraped so that the table is 0.005 mm higher at the front. Normally this would be more, but it is a very small milling machine and the load on the table will be very limited.
The table is scraped almost completely flat. Now need for oil pockets here.
The reconditioning of this fine little machine has been a great pleasure. All parts are small and easily manageable. Every part fits perfect on my granite surface plate, even the whole body of the machine. This makes measurements and aligning of the parts a fairly easy job.

Skriv en kommentar: (Klikk her)

123hjemmeside.no
Antall tegn tilbake: 160
OK Sender...

fernando Abad Cabrejas | Svar 02.04.2019 22.12

Maravilloso trabajo, y preciosa fresadora, yo también restauro maquinas, el problema es que te enamoras de ellas, y cada vez tienes mas maquinas y menos espacio

Se alle kommentarer

| Svar

Nyeste kommentarer

29.06 | 17:28

Kevin. Preload is correct when there is no play in de spindle.

...
29.06 | 02:32

HI i have a a question when you removed the main spindel was it easy ? hot do you insure you have put it back with the same thust applied?

...
18.05 | 09:01

Nice job, congratulation is very interesting, I' have own a Schaublin 1966, I bought it in 2003. I writing from Lima Perú.

...
10.04 | 22:50

Synes alle maskinene ser meget flotte ut.
Dette er bra. Har lyst til å lage en selv.

...
Du liker denne siden