TRAPANI ROSA

Machine cleaned up and with new bearings for the spindle. Still waiting for the new Albrecht super precision chuck. B10 spindle nose.
This machine was bought in 2014, now ready to be used.
Max rpm 18000, drill capacity 0-3 mm
This machine was previously used at Tandberg, a Norwegian radio factory.
Drilling circuit’s boards was probably the only use of this machine.

Skriv en kommentar: (Klikk her)

123hjemmeside.no
Antall tegn tilbake: 160
OK Sender...
Se alle kommentarer

| Svar

Nyeste kommentarer

13.08 | 21:37

Thank you. I only use oil and it is the same oil as the cutting oil. Good luck with your machine.

...
13.08 | 19:14

Hy, Very nice restoration of your sharp agathon, I'm restoring the same model. What do you use oil? or fat? for the slide bar and toolholder?best regards Olivie

...
15.02 | 16:15

Thank you for the fine compliments. I use a lot of emery paper, rotating steel brush and polishing paste. And many hours of work.

...
15.02 | 11:34

Wonderful job! How are you restoring the brilliant finish on non-painted surfaces such as the spindle nose, handles, dials?

...
Du liker denne siden