WRIGHT J-5 Part 2

Outside turning of the casting. Crank case.
Inside turning of the casting
Deckel optical rotary table. Marking out cylinders and valve lifters.
Pump centre for exact alignment
Finished crankcase (except for the bolting holes for the cylinder)
Front cover, crank case and compressor housing.
Copressor side.
Planetary gear housing.
18 BA6 screws. Tap drill 2.3 mm.
Gear box
Gear box

Skriv en kommentar: (Klikk her)

123hjemmeside.no
Antall tegn tilbake: 160
OK Sender...
Se alle kommentarer

| Svar

Nyeste kommentarer

13.08 | 21:37

Thank you. I only use oil and it is the same oil as the cutting oil. Good luck with your machine.

...
13.08 | 19:14

Hy, Very nice restoration of your sharp agathon, I'm restoring the same model. What do you use oil? or fat? for the slide bar and toolholder?best regards Olivie

...
15.02 | 16:15

Thank you for the fine compliments. I use a lot of emery paper, rotating steel brush and polishing paste. And many hours of work.

...
15.02 | 11:34

Wonderful job! How are you restoring the brilliant finish on non-painted surfaces such as the spindle nose, handles, dials?

...
Du liker denne siden